The short version of GHRH receptor fits in a sentence. The long version — which is the one that helps — is below.
This page was last updated on 2025-08-29 and is reviewed periodically as new material appears.
CJC-1295 is a synthetic peptide analog of growth hormone-releasing hormone, constructed on the 29-amino-acid fragment designated GRF(1-29). The name began as an internal development code during the 1990s and later spread through research supply catalogs and discussion forums. The molecule does not occur in nature; its sequence is engineered rather than isolated from tissue. Two related compounds are sold under this single label, and they differ by one appended chemical group that strongly influences how long the peptide remains in circulation.
The dividing feature between the two forms is a maleimide-based drug affinity complex, abbreviated DAC. In the DAC-bearing version, a linker attaches the peptide to serum albumin after administration, and that association slows removal from plasma. The version lacking DAC appears in catalogs as MOD GRF(1-29) or tetrasubstituted GRF(1-29). Because informal writing treats both as one item, comparisons drawn from such sources routinely blend measurements taken from two molecules with substantially different behavior.
Clearance profiles diverge sharply between the two versions. The albumin-binding molecule stays in plasma for several days, whereas the unmodified analog is largely gone within about half an hour in reported work. Cleavage by dipeptidyl peptidase IV is a major contributor to the short life of the unmodified sequence. These gaps mean the two versions cannot be substituted for each other in study design or in reading results side by side.
Reports on this compound commonly follow serum growth hormone and insulin-like growth factor 1 across defined time windows. Protocols differ in sampling frequency, assay platform, and participant characteristics, which makes direct comparison between publications difficult. Some work focuses on pulsatile release patterns instead of average concentrations. Whether repeated exposure alters endogenous hormone rhythms over long periods remains an open question, and the formal literature is thinner than the volume of informal commentary implies.
Once in circulation, the peptide binds the growth hormone-releasing hormone receptor displayed on pituitary somatotroph cells. Receptor activation couples to Gs proteins, elevates intracellular cyclic AMP, and drives protein kinase A signaling inside the cell. That cascade increases discharge of growth hormone into the bloodstream. The analog therefore operates through a receptor pathway that already exists for the body's own releasing hormone, rather than through an engineered artificial target.
| Property | Value | Notes |
|---|---|---|
| Molecular class | Synthetic peptide | Analog of growth hormone-releasing hormone |
| Chain length | 29 amino acids | Based on the GRF(1-29) fragment |
| Appearance | White to off-white lyophilized powder | Common research supply form |
| Solubility | Soluble in water and aqueous buffers | Powder requires reconstitution before use |
| Typical storage | −20 °C or below | Kept away from light and moisture |
CJC-1295 is a synthetic peptide built as a long-acting analogue of growth hormone-releasing hormone. Its backbone matches the first twenty-nine residues of the natural human hormone, with four amino acid substitutions added to slow enzymatic breakdown. A reactive maleimide group, commonly termed the drug affinity complex, allows the peptide to attach to circulating albumin after administration. That albumin attachment keeps the molecule in the bloodstream for an extended period instead of being cleared within minutes.
The compound emerged from work at a Canadian biotechnology firm in the early 2000s. Early human studies examined its effect on growth hormone and insulin-like growth factor 1 in healthy volunteers and in people with HIV-associated fat redistribution. Reports described sustained increases in both markers after a single injection. Development did not advance to regulatory approval, and the clinical programme was later discontinued. The molecule is now encountered mainly as a research chemical rather than a marketed medicine.
Two forms circulate in research settings and are frequently confused. One carries the drug affinity complex and is often written as CJC-1295 with DAC; the other lacks that group and is usually called modified GRF(1-29). The two share the same core sequence but differ sharply in how long they persist in blood. Products labelled only as CJC-1295 normally refer to the version carrying the complex. Documentation that omits the distinction leaves the intended molecule ambiguous.
CJC-1295 acts at the growth hormone-releasing hormone receptor, a G-protein-coupled receptor found on somatotroph cells in the anterior pituitary. Binding triggers a rise in cyclic AMP and calcium entry, which promotes release of stored growth hormone. Because the peptide mimics the body's own releasing hormone, it amplifies existing secretory pulses rather than driving continuous output. The size of the response therefore depends partly on the subject's own hormonal rhythm and feedback state.
The attached maleimide group explains the unusual duration of the DAC version. After injection it reacts with the thiol of cysteine-34 on serum albumin, forming a stable covalent bond. The resulting conjugate is too large for rapid kidney filtration and is shielded from many peptidases. Reported half-lives for this form reach several days, whereas the version without the group is cleared in roughly half an hour. That gap is the main pharmacological difference between the two.
Downstream of growth hormone, the liver and other tissues increase production of insulin-like growth factor 1, a mediator of many growth-promoting effects. Studies have documented elevated levels of both hormones after dosing, and the rise from the long-acting form persists longer than that produced by shorter-acting analogues. What remains unclear is whether sustained elevation of these markers translates into meaningful clinical benefit, and whether prolonged exposure carries risks that short trials could not detect.
Stability depends heavily on physical state. A lyophilized powder kept dry, desiccated, and shielded from light typically holds its integrity for months to years at minus twenty degrees Celsius, and longer at minus eighty. Once dissolved, the peptide becomes far more vulnerable, since peptide bond hydrolysis, oxidation of susceptible residues, and aggregation all proceed faster in solution. Buffers near neutral pH are generally gentler than strongly acidic or alkaline conditions. Repeated freeze-thaw cycles and exposure to air-liquid interfaces during vigorous mixing cause losses that are easy to overlook.
Verification matters because research peptides vary widely in quality. A certificate of analysis is only as reliable as the method behind it, and a single chromatographic trace reveals little about counter-ions, residual solvents, or water content. Independent laboratories commonly pair mass confirmation with chromatographic purity and, where relevant, quantify water along with acetate or trifluoroacetate content. Reported purity figures are not standardized across suppliers, so a stated value such as ninety-eight percent is not directly comparable unless the analytical method, column, and detection wavelength accompany it.
Lyophilised powder is the usual supplied form. The material is hygroscopic, so vials are typically equilibrated to room temperature before opening in order to prevent condensation on the contents. Long-term storage is generally described at minus twenty degrees Celsius or colder, protected from light and moisture. Repeated freeze-thaw cycles are avoided because they promote aggregation and loss of soluble material. A reconstituted solution is considerably less stable than the dry powder and is normally kept refrigerated for short periods only.
Identity and purity are assessed mainly by reversed-phase high-performance liquid chromatography combined with mass spectrometry. The chromatographic separation resolves the target peptide from truncation products and from species carrying oxidised residues, while mass measurement confirms the expected molecular mass. Because the two common variants differ by roughly 280 daltons, a mass determination distinguishes them unambiguously. Purity is often quoted as a percentage of total peak area, although that figure depends on the detection wavelength and the integration method applied.
Reported half-lives differ widely between the two variants and between species. Values for the albumin-binding form are usually expressed in days, while the unconjugated form is measured in minutes to a few hours. Sampling schedules, assay sensitivity, and route of administration all influence the numbers, which limits direct comparison across studies. Whether sustained receptor occupancy produces different downstream effects from pulsatile stimulation remains an open question in the published work. Claims about relative potency should therefore be read alongside the specific study design that produced them.
An estimated 1,680 million people died of infectious diseases in the 20th century and about 10 million in 2010. The World Health Organization collects information on global deaths by International Classification of Disease (ICD) code categories. The following table lists the top infectious disease by number of deaths in 2002. 1993 data is included for comparison.
=== Epoxy resin curing agents === Amines are often used as epoxy resin curing agents. These include dimethylethylamine, cyclohexylamine, and a variety of diamines such as 4,4-diaminodicyclohexylmethane. Multifunctional amines such as tetraethylenepentamine and triethylenetetramine are also widely used in this capacity. The reaction proceeds by the lone pair of electrons on the amine nitrogen attacking the outermost carbon on the oxirane ring of the epoxy resin. This relieves ring strain on the epoxide and is the driving force of the reaction. Molecules with tertiary amine functionality are often used to accelerate the epoxy-amine curing reaction and include substances such as 2,4,6-Tris(dimethylaminomethyl)phenol. It has been stated that this is the most widely used room temperature accelerator for two-component epoxy resin systems.
== Further reading == Smith, N. "Capillary ElectroChromatography" Available at:https://www.beckmancoulter.com/wsrportal/bibliography?docname=AP8508ACECPrimer.pdf Bartle, K. D. Capillary ElectroChromatography Published by The Royal Society of Chemistry, Cambridge. ISBN 0-85404-530-9
Dysprosium perchlorate is an inorganic compound of dysprosium and the perchlorate ion, with the formula Dy(ClO4)3. It is known as an anhydrous salt and in hydrated forms, including the hexahydrate Dy(ClO4)3·6H2O. The anhydrous compound adopts the hexagonal structure characteristic of many rare-earth perchlorates.
Sources: en.wikipedia.org
== Etymology == The word "soy" derives from the Japanese soi, a Kagoshima dialect variant of shōyu, which in turn comes from the Chinese jiangyou (醬油), meaning "soy sauce". The name of the genus, Glycine, comes from Linnaeus. When naming the genus, Linnaeus observed that one of the species formerly within the genus, which has since been reclassified to the genus Apios, had a sweet root. Based on the sweetness, the Greek word for sweet, glykós, was Latinized.
=== Current === Alex Lifeson – electric and acoustic guitars, backing vocals, synthesizers, keyboards (1968–2015, 2025–present) Geddy Lee – lead and backing vocals, bass, keyboards, synthesizers, guitar (1968–1969, 1969–2015, 2025–present), lyrics (1973–1974)
=== Genetic predisposition === The genetic locus most significantly associated with Sjögren’s is the major histocompatibility complex/human leukocyte antigen (MHC/HLA) region, as demonstrated by the preliminary results of the first genome-wide association study. This study included data from a discovery cohort of 395 patients of European ancestry with primary Sjögren's disease, and 1,975 healthy control individuals, and from a replication study that comprised 1,234 cases and 4,779 healthy controls. Associations with polymorphisms located at six independent loci were also detected; IRF5, STAT4, BLK, IL12A, TNIP1, and CXCR5. This also suggested the activation of the innate immune system, notably through the IFN system, B-cell activation through CXCR5-directed recruitment to lymphoid follicles and B-cell receptor (BCR) activation involving BLK, and T-cell activation owing to HLA susceptibility and the IL-12-IFN-γ-axis. Patients of different ethnic origins carry different HLA-susceptibility alleles, of which HLA-DR and HLA-DQ are involved in the pathogenesis of Sjögren's disease. For example, patients from Northern and Western Europe and North America show a high prevalence of B8, DRw52, and DR3 genes. HLA class II alleles are associated with the presence of specific subsets of autoantibodies, rather than with the disease itself. Autoantibodies refer to the loss of B-cell tolerance leading to the production of antibodies directed against diverse organ-specific and organ-nonspecific antigens.
Sources: en.wikipedia.org
No. It is a laboratory-synthesized analog built on a fragment of the natural hormone. The natural peptide is shorter-lived and lacks the stabilizing substitutions found in the synthetic version.
DAC stands for drug affinity complex, a chemical group that binds the peptide to serum albumin. The binding slows clearance and lengthens the time the molecule stays in plasma compared with the unmodified analog.
Because two distinct molecules are discussed under one informal label. The albumin-binding version clears over several days, while the form without that group clears within roughly half an hour. Mixing results from both creates inconsistent figures.
It acts on the growth hormone-releasing hormone receptor found on pituitary somatotroph cells. Activation of that receptor triggers growth hormone release through a cyclic AMP dependent pathway.